Peel and Stick Coatings
Our FluoroGrip® product coating line offers the highest chemical resistance and temperature solution for your corrosion needs with easier and safer installation over traditional coatings at a lower lifetime cost. FluoroGrip® is available in a variety of fluoropolymers combined with pressure sensitive adhesives that are tailored to suit any coating requirement. These film systems are available in a variety of fluoropolymer grades (FEP, PTFE, ECTFE, PVDF, ETFE, PFA, and MFA) at thicknesses and sizes to fit your unique coating needs.
Ease of Installation
- Minimal surface preparation required
- Applied in a single application process
- Can be applied at temperatures as low as 40°F and may be used in service up to 500°F
- Can be applied in environments not suitable for traditional coatings
- Bonds immediately to the substrate significantly reducing downtime
- No multi-coats or reinforced material required
One-Step Application
- Surface is cleaned to remove any contaminants
- A release liner is peeled from the back of the FluoroGrip® film
- Exposed adhesive side is then applied by hand or mechanical pressure
- Solid sheet design assures consistent coverage even on edges and corners
- Can be cut to customize apply to any substrate and wrap around complex geometric surfaces
Safer
- No VOCs or hazardous solvents
- No solvent related protective clothing or equipment required
- Environmentally safer for handling and shipping
- Eliminates the disposal of hazardous waste
Less Cost
- Reduced labor, installation and downtime costs
- Prevents coating failures associated with traditional coatings
- No expensive application equipment required
- Extended service lifetime of service yielding cost effective solutions
- No costly waste disposal
Compare FluoroGrip® to other commonly used coatings and lining
Traditional* Coatings/Linings |
Thick Sheet Fluoropolymer Linings | FluoroGrip® | |
---|---|---|---|
Advanced peel & stick installation technology | • | ||
No VOCs, noxious fumes or explosive hazards | • | ||
Minimal surface preparation | • | ||
No thinners or primers | • | • | |
Minimal installation inspection requirements | • | • | |
Elongation and high chemical resistance | • | • | |
Ease of repair | • | • | • |
No cure time | • | • | |
No disposal of hazardous wastes | • | • | |
High temperature resistance to 500°F | • | • | |
Cost-effective | • | • |
*Epoxies, Vinyl Esters, Novolacs