Home About Us Trade Shows Resources Related Links Case Histories Contact Us Integument Is A Leading Industrial Coating Company And Industrial Adhesive Coating Manufacturer Our Science • Our Science Overview • Plasma Treatment Techno. • Surface Treatment • Toll Treating Capabilities • Infusion Processes Our Products • Our Products Overview • Films & Sheets • Tapes & Wraps • Film Availability • Optically Clear Film • Membrane Film • Metalized Film • Sealants & Caulks • Primers & Toppings Product Applications • Range of Applications • External Coatings • Anti-Graffiti • Concrete Systems • Pipe Wraps • Transportation Equipment • Lightning Strike Appliqués • Paint Repair & Maintenance • Architectural • Coil & Duct • Composite Fabrication Chemical Resistance Data • General Film Guide • ECTFE Resistance Data Concrete Systems (You will need free Adobe Acrobat Reader available HERE)   Click here for Secondary Containment Technical Data Sheet Click here for Joint and Crack Sealant System Technical Data Sheet Click here for Expansion Joint Technical Data Sheet Click here for Concrete Filler/Sealer Technical Data Sheet Read case history article on Secondary Containment FluoroGrip® concrete systems combine the best of chemical resistant toppings (vinyl ester, epoxy-novolacs, etc.) with fluoropolymer membrane technologies to provide unparalleled protection of concrete containment areas. Toppings range from 1/16" - 3/8" thickness. Final thickness is dependent upon type and frequency of traffic. Pump pads, and vertical surfaces simply incorporate a concrete filler/sealer to prepare the surface prior to installing a fluoropolymer sheets from 5-20 mils thickness. Fully fluorinated, elastomeric expansion joint and crack bridging systems for extreme chemical environments and secondary containment. FIGURE 1: Engineered secondary containment systems utilizing fluoropolymer films with proprietary advanced-adhesive technologies. FIGURE 2: Application of epoxy fillers & sealers to prepare concrete. FIGURE 3: Saw cut to facilitate embedded top termination. FIGURE 4: Fluoropolymer with pre-applied adhesive and film being installed over optional conductive primer. FIGURE 5: Application ties into existing surfaces. 72 Pearce Avenue, Tonawanda, NY 14150 • Phone 716-873-1199 • Fax 716-873-1303 • info@integument.com Copyright © 2008, Integument Technologies, Inc. All Rights Reserved.